Trying a simple model
Trying a simple model
I have taken a simple portion from one of the included examples with the blockset to create a blinking LED. I have a dsPIC30f4011 and a dsPICDEM2 board, along with MPLAB ICD 2. No matter what, I can't get a single LED to light up. I am very new to this, and I need some direction. I've attached the simulink model I've been using. Thank you!
- Attachments
-
- blink_led.mdl
- (25.75 KiB) Downloaded 705 times
-
LubinKerhuel
- Site Admin - Expert
- Posts: 616
- Joined: Wed Mar 07, 2007 11:23 pm
- Location: Bayonne- France
- Contact:
Re: Trying a simple model
Hey,
You model is not far from working.
I think that the problem is the oscillator mode that seems not correct.
Do you use a quartz. If so, Oscillator mode should be something like XT, XT with Pll or HS. See 30f4011 doc to get further information about oscillator.
Lubin
You model is not far from working.
I think that the problem is the oscillator mode that seems not correct.
Do you use a quartz. If so, Oscillator mode should be something like XT, XT with Pll or HS. See 30f4011 doc to get further information about oscillator.
Lubin
Who is online
Users browsing this forum: No registered users and 30 guests