but the master of this forum has done.so I decide to change my purpose to use this tool.
However, target for dsPIC makes some troubles..
so I can't try the examples on the web site.
1. windows character encoding problem
the toolbox is made with 'windows-1252'
'windows-949' is used in my coutry..
When load the "\blocks\dsPICdrivers.mdl", 2 kind of errors are occured.
'§' and '°' character makes troubles.
korean is one of representative 2-byte characters. Therefore it runs well on the korean windows, I expect that it runs well on other 2-byte chracter system.
http://cafefiles.naver.net/data26/2007/ ... st4u78.jpg
I'm using the slCharacterEncoding() function to avoid the upper problem.
using the 'windows-1252', I cann't save well. so this must be improved.
2. master & configuration block error
when double clicking the both blocks to set the master block and configuration block, the system show the following errors.
Master block settings are not shown. How can I avoid the messages?
http://cafefiles.naver.net/data26/2007/ ... st4u78.jpg
http://cafefiles.naver.net/data26/2007/ ... st4u78.jpg
P.S > I hope that this article can contain the image files.
I can't upload the images, link is just allowed.
It's very inconvenient..
