Hello,
I am an undergraduate in electrical and computer engineering. I am using the digital output write peripheral to output an 8-bit number. However it is telling me that I cannot use this many I/O pins for this toolbox. Can anyone suggest why this is happening and how to fix it?
dsPIC33fj256GP710A
-
migueleteabril
- Posts: 1
- Joined: Fri Feb 21, 2014 5:38 pm
Re: dsPIC33fj256GP710A
Your version of the Embedded Coder for dsPIC Toolox support model using 7 I/O pins for the selected PIC. Your Simulink Diagram uses too many I/O pins. Considere purchasing the toolbox. Informations available on http://www.kerhuel.eu
Where is the full version?
Where is the full version?
Who is online
Users browsing this forum: No registered users and 1 guest