Hi,
I was wondering if there is a way to 'turn off' the Tx block. At a certain point in my program I want to stop sending data to the serial port, but even if I conditionally disconnect the inputs of the Tx block with a switch, the Tx block still constantly sends '0'.
Thanks!
Tx block
-
- Site Admin - Expert
- Posts: 616
- Joined: Wed Mar 07, 2007 11:23 pm
- Location: Bayonne- France
- Contact:
Re: Tx block
Hi caeowens,
Place the Tx block within an "enabled subsystem" that you could then activate or not at will...
Lubin
Place the Tx block within an "enabled subsystem" that you could then activate or not at will...
Lubin
Who is online
Users browsing this forum: No registered users and 5 guests