Blockset described on this wiki is deprecated since 2012.

For Model Based Design (MBD), use the free MPLAB Device Blocks for Simulink, tool from Microchip.
Updated Rapid Control Prototyping (RCP) custom projects are published at: https://lubin.kerhuel.eu.

Difference between revisions of "Licence"

From http://www.kerhuel.eu/wiki - Simulink device driver Blockset for dsPIC / PIC24 / PIC32 Microcontrollers --[[User:LubinKerhuel|LubinKerhuel]] 12:40, 3 September 2009 (UTC)
Jump to navigation Jump to search
m (Protected "Licence" [edit=sysop:move=sysop])
Line 27: Line 27:
  
  
'''NOTE : I will be out of office from the 1st of august until 1st of september. Thus, no transaction during august.'''
+
'''NOTE : I will be out of office from the 1st of august until 1st of september.'''
  
  

Revision as of 18:34, 9 August 2008

Before acquiring a licence of the PIC blockset for Simulink, try the free evaluation version and make sure that the PIC peripheral are properly programmed by the blockset on your targeted PIC or dsPIC microcontroller.

Licence type

Pricing depends on the max number of I/O microcontrollers PINs that can be used within a simulink model. The version include all devices supported by the demonstration version (see the [download] page)

Max IO Pins 6 8 10 12 14 16 inf
for Accademic & Hobbist Free 90€ 150€ 210€ 270€ 330€ 600€
for Buisness Company! - 200€ 250€ 375€ 500€ 625€ 1000€

The price is a license for 1 user. For other type of licence, please contact

Procedure

Credits card accepted through paypal.

Procede in three steps :

  • Copy-past and complete the following text in an Email to RTWdspic@kerhuel.eu
complete word $between$ or delete one of the proposition between $a/b$
  • You will then receive after few days (0 to 5) an email from paypal. From this email, you could pay using a credit cards or a paypal account.
  • Once payement is confirmed, you will received few days later the blockset on the same email address.


NOTE : I will be out of office from the 1st of august until 1st of september.



mail subject :

Buy dsPIC blockset $Accademic/Buisness$, $Number Ports (inf otherwise)$

Text to copy and modify


I Want to buy the $Accademic/Buisness$ version with $Numer Pins$ I/O for Matlab $R2006a / R2006b / R2007a / R2007b / 2008a$.
Name : $Your Name$
Company or university: $company or unisversity$
For university or hobbist , could you write a short description of your project here ?


I read and agree with the following condition :
Unless otherwise stated, the software will be provided "as-is," without any express or implied warranty. In no event shall Lubin KERHUEL be held liable for any damages arising from the use of the software.
Unless otherwise stated, the software on this site is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. THERE IS NO WARRANTY FOR THE SOFTWARE, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS PROVIDE THE SOFTWARE "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE SOFTWARE IS WITH YOU. SHOULD THE SOFTWARE PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION. IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE SOFTWARE (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE SOFTWARE TO OPERATE WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.