Port Info block annotation

Post Reply
bmairs
Posts: 69
Joined: Mon Jul 27, 2009 7:51 pm

Port Info block annotation

Post by bmairs » Fri May 13, 2011 7:21 pm

Can the port info block be extended to include a mask where the individual pins can be manually annotated. This would be very useful for documentation.

So if I was using two pins: RA0 and RA1 I could double-click on the block and the mask parameters would pop up and I could add notes about those pins. So I could add "Reset status - LED D3" and "HIL status - LED D4" into those notes. The block would then display the notes on the front along with the pin and associated peripheral.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests