Rs 232 Gui Interface with PIC 32 starter kit

Post Reply
chandupotluri
Posts: 1
Joined: Thu Dec 16, 2010 12:27 am

Rs 232 Gui Interface with PIC 32 starter kit

Post by chandupotluri » Thu Jan 20, 2011 2:35 am

Hello Lubin,

I am using PIC 32 statrter kit. I am reading the data from the ADC and want to transmit through UART to PC. PIC 32 starter kit only has a USB. When I am trying to establish the connection through COM port 3 it is doing it. But I am not able to see any data that is being received. I tried doing all the suggestion you made in forum for a similar problem but was unsucessfull. I am just wondering if there is away to connect the comm ports through the USB. I am also attaching my model as a reference.

Thanks in advance.
Attachments
trail5freqchangeBandF_analog_uart1.mdl
(37.27 KiB) Downloaded 258 times

LubinKerhuel
Site Admin - Expert
Posts: 616
Joined: Wed Mar 07, 2007 11:23 pm
Location: Bayonne- France
Contact:

Re: Rs 232 Gui Interface with PIC 32 starter kit

Post by LubinKerhuel » Tue Feb 15, 2011 10:33 pm

Hi,

I hardly use this starter kit. As far as I remember, It is not possible to connect to the dsPIC UART from the USB. (I think that USB is connected to a PIC with USB peripheral which may act as a bootloader only).

Try to find an available UART pin on the board. You may then connect the two pin (Rx-Tx) with a FTDI cable.

Lubin

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest