Port Info block annotation

bmairs
Posts: 69
Joined: Mon Jul 27, 2009 7:51 pm

Port Info block annotation

Postby bmairs » Fri May 13, 2011 7:21 pm

Can the port info block be extended to include a mask where the individual pins can be manually annotated. This would be very useful for documentation.

So if I was using two pins: RA0 and RA1 I could double-click on the block and the mask parameters would pop up and I could add notes about those pins. So I could add "Reset status - LED D3" and "HIL status - LED D4" into those notes. The block would then display the notes on the front along with the pin and associated peripheral.

Return to “Request for new functions / Peripheral / Chip support”

Who is online

Users browsing this forum: No registered users and 4 guests