delay between PWM

Post Reply
ELMAY
Posts: 14
Joined: Wed Feb 09, 2011 2:45 pm

delay between PWM

Post by ELMAY » Fri Feb 25, 2011 10:59 am

hi sir

I made this model to generate 3 PWM I compile without errors

This now I ask the following:

how can there be a delay between these 3 signals?

ELMAY
Attachments
commande_IGBT.mdl
(34.75 KiB) Downloaded 395 times

LubinKerhuel
Site Admin - Expert
Posts: 616
Joined: Wed Mar 07, 2007 11:23 pm
Location: Bayonne- France
Contact:

Re: delay between PWM

Post by LubinKerhuel » Sat Feb 26, 2011 8:49 pm

Here is your model:
Elmay's model Commande_IGBT
Elmay's model Commande_IGBT
ELMAY wrote: how can there be a delay between these 3 signals?
I do not think there is a robust way to do it.
Anyway, you may try the Output Compare Hardware (OC (HW)) (instead of the Output Compare (OC)) block which I used for picooz motor control or this other example .

With OC (HW) block, mode 16 makes you able to set for each channel the instant at which you want a rising edge and at which instant you want a falling edge. However, due to the way it works, a PWM duty cycle may be false for one period when you are modifying values.

Lubin

Post Reply

Who is online

Users browsing this forum: No registered users and 15 guests