Page 1 of 1

I2C master block

Posted: Thu Mar 21, 2013 2:23 pm
by HeleneCT
Hello everybody,

I am having trouble using this bloc.
I might haven't seach well but I did not found any example using the read and write on the I2C. Is there such a thing somewhere?

Could someone explain the bus frequency thing. I have a dspic33 and the datasheet says it allows 100k and 400kHz bus frequency but the bloc have a lot of different frequencies.
I have seen thas if I change it the displayed frequency changes too but what is the relation between them ?

I was also wondering why is there only the master bloc and nothing for slaves.

Thanks,
Helene