Hello everybody,
I am having trouble using this bloc.
I might haven't seach well but I did not found any example using the read and write on the I2C. Is there such a thing somewhere?
Could someone explain the bus frequency thing. I have a dspic33 and the datasheet says it allows 100k and 400kHz bus frequency but the bloc have a lot of different frequencies.
I have seen thas if I change it the displayed frequency changes too but what is the relation between them ?
I was also wondering why is there only the master bloc and nothing for slaves.
Thanks,
Helene
I2C master block
Who is online
Users browsing this forum: No registered users and 4 guests