Page 1 of 1

Tx block

Posted: Wed Aug 03, 2011 11:07 pm
by caeowens
Hi,
I was wondering if there is a way to 'turn off' the Tx block. At a certain point in my program I want to stop sending data to the serial port, but even if I conditionally disconnect the inputs of the Tx block with a switch, the Tx block still constantly sends '0'.
Thanks!

Re: Tx block

Posted: Fri Aug 12, 2011 10:43 pm
by LubinKerhuel
Hi caeowens,

Place the Tx block within an "enabled subsystem" that you could then activate or not at will...

Lubin