Rapid Prototyping with 16/32 bits MCU

Hi all

I have a PIC32 starter kit.
http://www.microchip.com/stellent/idcpl ... e=en532453

I would like to use the block set provided by Mr Kerhue.

It is possible?

Hi,

The PIC32 used in this starter kit (32MX795L512) is not yet available in the blockset.
Thus, using the blockset for this chip is not possible at the moment.
I have to check what are the differences with supported PCI32 and to adapt the blockset consequently.

Subscribe to the wiki's release note webpae to get mail at each update. You will be noticed of blockset evolutions.

Lubin