Page 1 of 1
problem in output fuzzy
Posted: Fri Nov 28, 2008 12:28 pm
by akd
I need to use the fuzzy as shown in the matlab file that increase and then be constant then decrease to zero the problem I get that when I load it in the dspic 30f6014 that I use I did not get the response from the output of dspic that i use the oscilloscope to see the response.
Re: problem in output fuzzy
Posted: Mon Dec 08, 2008 8:59 pm
by LubinKerhuel
I do not have the fuzzy logic blockset. Could not help here !
Lubin
Re: problem in output fuzzy
Posted: Mon Dec 15, 2008 6:37 pm
by akd
hi LubinKerhuel thank you for reading my subject.
I used the fuzzy as it shown in the matlab file but the problem I find it that when I start it the output show me zero and i did not get the responce i need.