does not appear Interface tx-Matlab

Create new topics, add your comment, remark, bugs...
Post Reply
hetfieldcp
Posts: 1
Joined: Wed May 21, 2008 4:49 pm

does not appear Interface tx-Matlab

Post by hetfieldcp » Fri Jun 06, 2008 8:01 pm

Hello.
I installed install_dsPIC_R2008a, I do not see the block "dbl-click to open Graphical Interface." I could give any solution.
Thank you for your prompt response.

German Enrique Cruz
Greetings from Chile.

Hola.
He instalado install_dsPIC_R2008a, no me aparece el bloque "dbl-clic to open Graphical Interface". Me podrían dar alguna solución.
Gracias por su pronta respuesta.

Germán Enrique Cruz
Saludos desde Chile.

LubinKerhuel
Site Admin - Expert
Posts: 616
Joined: Wed Mar 07, 2007 11:23 pm
Location: Bayonne- France
Contact:

Re: does not appear Interface tx-Matlab

Post by LubinKerhuel » Fri Jun 06, 2008 9:49 pm

Are you looking for this block ?
Block_Interface_TxMatlab.png
Block_Interface_TxMatlab.png (1.13 KiB) Viewed 7595 times
Double click on this block is the equivelent to type at the matlab prompt :
>> rs232gui

Stefano
Posts: 5
Joined: Wed Jun 11, 2008 11:35 am

Re: does not appear Interface tx-Matlab

Post by Stefano » Wed Jun 11, 2008 1:37 pm

I have the same problem. In the "Simulink library browser" -> "Embedded Target for Microchip dsPIC" -> "Serial port" the "Interface Tx-Matlab" block is not visible, even if the Matlab command "rs232gui" works fine. To use the "Interface Tx-Matlab" block I have to click with the right mouse button on the library "Serial port" in the "Simulink library browser" and select "Open the serial port lybrary", in this way the block shows up.
I hope this can help.

PS: I'm using Matlab R2007b

LubinKerhuel
Site Admin - Expert
Posts: 616
Joined: Wed Mar 07, 2007 11:23 pm
Location: Bayonne- France
Contact:

Re: does not appear Interface tx-Matlab

Post by LubinKerhuel » Thu Jun 12, 2008 12:14 am

Hi, Thanks for reporting this problem. It should be solved on the very last version of the blockset 0.98c, experimental now. (download if only from the release note page ; Bottom of the page)

Post Reply

Who is online

Users browsing this forum: No registered users and 34 guests