Search found 5 matches
- Sat Mar 10, 2012 8:36 pm
- Forum: General Remark and Questions
- Topic: send and receive multiple data using GUI
- Replies: 9
- Views: 26775
Re: send and receive multiple data using GUI
Hi again Saeed, I am not sure that this block you used (Data Store Write) is suitable for burning on the dsPIC.. remember that this block is transferred to C code. Again I am not sure, I started using these blocks just a few months ago as well. As for your questions: 1. I attached 2 simulink models:...
- Sat Mar 10, 2012 11:45 am
- Forum: General Remark and Questions
- Topic: send and receive multiple data using GUI
- Replies: 9
- Views: 26775
Re: send and receive multiple data using GUI
Hello again, I can see that the BaudRate in your dsPIC is 19200, and in the Real-Target the BaudRate is 9600. You should change the settings (Serial Port, and BaudRate) until the test passes. Are you sure that the Serial Port is COM2? You can check that by going to Manage, and check the PORT connect...
- Tue Mar 06, 2012 9:26 am
- Forum: General Remark and Questions
- Topic: send and receive multiple data using GUI
- Replies: 9
- Views: 26775
Re: send and receive multiple data using GUI
Hello Saeed, I see that you used Lubin's rs232 GUI block. If you wish to use this block you need to open it (by the way, you dont have to burn it on the dsPic's block diagram) select the COM Port you have connected your device to (the dsPIC or other device) select the BaudRate (this is important!! y...
- Thu Mar 01, 2012 8:53 am
- Forum: General Remark and Questions
- Topic: send and receive multiple data using GUI
- Replies: 9
- Views: 26775
Re: send and receive multiple data using GUI
Hello Saeed, There are a few options for sending data from the Matlab/Simulink to the dsPIC: 1. Open a serial port in the Matlab command line using "serial" command, and send data using "fwrite" command. Pros: you can create a GUI. Cons: you need a good understanding in Matlab. 2. send data using si...
- Sun Feb 05, 2012 2:31 pm
- Forum: General Remark and Questions
- Topic: send and receive multiple data using GUI
- Replies: 9
- Views: 26775
send and receive multiple data using GUI
Hello lubin, I am tring to send and receive data thru UART from dsPIC30F4011 to the comp. I am using your block "Tx Output Multiplexed For Matlab-Labview" and I was wondering what are the variables I need to insert in order to send data thru this block to the dspic (instead of sending with the send ...