Rapid Prototyping with 16/32 bits MCU

Hi Lubin

I have installed the latest verion of the toolbox for Matlab 2007a ,
I am able to comple all the examples succesfully with this version no problems at all

Best regards
Peter

Hello Lubin I would also like to see some CAN modules as CAN is widely used and will be in the industrie for some years to come. I work with CAN intensivly and have a CAN test bench with a couple off CAN nodes on a Bus . If it would help you I can help you in testing and running the code generated f...

Hi Lubin
Do I have to remove the old version files first from my folder C\toolbox and then copy new version files again into this folder and reinstall it in matlab as with the old version ,I am just afraid things stop to work now
Thanks
Best Regards
Peter

Dear Lubin
I have upgraded to 2007 matlab and now the toolbox is working ,
I would like to buy a full verion of the toolbox with out any limitation on the number of pins used
Thank you for your reply
Regards
Peter

Dear Lubin
Thank you for the reply it is clear ,
I will update in the near future
Thanks and sorry for this
Best Regards
Peter

I am sorry once again

Hallo Lubin Yes I am sure the problem is not in the RTw it is with my matlab or with my setup or with the instulation of the RTW . I am using MATLAB 7.01 I can not do the tutorial for the following reasons (1) when I select the tlc file in the Configuration RTW workshop matlab reports and error with...

Hallo Lubin I am sorry I am so stupid I just cant get the RTW to run I have done the update function as you sugested in the last post here is an extract of the error messages Thanks a lot Peter Warning: The dialog of 'untitled/Master' is being closed because a mask parameter has been changed. > In d...

Hallo Lubin

Thank you for the reply,
I will try to do the tutorial and see if I am able to simulate and generate the code


Best Regards
Peter

Hi Lubin Here is a copy of the error message in the work space It appears after I select the dsPIC.tlc filein the sim properties -> Real time workshop Thanks Warning: Error evaluating 'CopyFcn' callback of Master block (mask) 'Master'. Error using ==> dsPIC_ConfigRTWOption The *System Target File mu...

Hallo Lubin Thank you for the reply , I have refreshed the matlab path and I can now see the dsPIC.tlc in the simulink properties however when I select it it brings the message error FCN callback main block Please help me I really want to stert to us simulink Thanks Peter ps the toolbox is installed...

Hallo I have installed the toolbox and if I place the master block on the simulink page and select configure simulink I can not fine the dspic.tlc file as the tutorial shows
Please help
Thanks